X-Git-Url: https://repo.jachan.dev/J-u-boot.git/blobdiff_plain/38546f08c608b871a65bd538b9c460b3348b1261..15616a0aa58173bce1efe47569bf2e10d023ae9c:/doc/README.serial_multi

diff --git a/doc/README.serial_multi b/doc/README.serial_multi
index 40f78159f59..c9049fd01d6 100644
--- a/doc/README.serial_multi
+++ b/doc/README.serial_multi
@@ -35,7 +35,7 @@ just after switching the console:
 	setenv sout serial_scc; setenv baudrate 38400
 
 After that press 'enter' at the SCC console. Note that baudrates <38400
-are not allowed on LWMON with watchdog enabled (see CFG_BAUDRATE_TABLE in
+are not allowed on LWMON with watchdog enabled (see CONFIG_SYS_BAUDRATE_TABLE in
 include/configs/lwmon.h).
 
 
@@ -52,29 +52,3 @@ PPC4XX Specific
 	setenv stdout serial0
 	setenv stderr serial0
 	setenv stdin serial0
-
-MPC5xxx Specific
-================
-
-Up to two PSCs can be used as console.
-
-Support for hardware handshake has not been implemented yet.
-
-*) The first (default) console port is defined by:
-	#define CONFIG_PSC_CONSOLE <PSC number>
-
-*) The second (alternative) console port is defined by:
-	#define CONFIG_PSC_CONSOLE2 <PSC number>
-
-*) Commands to switch to the second console:
-	setenv stdout serial1
-	setenv stderr serial1
-	setenv stdin serial1
-
-*) Commands to switch to the first console:
-	setenv stdout serial0
-	setenv stderr serial0
-	setenv stdin serial0
-
-*) If a file descriptor is set to "serial" then the
-   current serial device will be used.